2 English reviews written for ZODIAC MK8 CRB Nozzle
5 customer reviews in all languages
| 5 stars | | 5 | (45%) |
|---|---|---|---|
| 4 stars | | 0 | (0%) |
| 3 stars | | 2 | (18%) |
| 2 stars | | 1 | (9%) |
| 1 Stars | | 3 | (27%) |
Filter reviews:
-
Mark
03 November 2021
"Verified Purchase" indicates that the rating was given by customers who actually bought this product from us. However, anyone who has a customer account with us can give a rating. -
Catherine Wiles
16 November 2020
"Verified Purchase" indicates that the rating was given by customers who actually bought this product from us. However, anyone who has a customer account with us can give a rating. Not overly impressed
Rated with 2 out of 5 stars.
For the amount I paid I would have expected it not to stick to the nozzle but it did I could use cheaper ones and get a better result I have removed it after several attempts and gone back to my usual ones. Waste of money.
Was this rating helpful? (8) (8)
Magazine Articles:
Discover 3DJake:
-
Switzerland: Free standard delivery from CHF 69.90
-
Delivery in 3 business days.
More than 10.150 products
We deliver worldwide to
more than 40 countries
Lots of big words = Unimpressive
Rated with 3 out of 5 stars.
Ok, so this was a 'what the heck' buy when my go to BROZZL plated was out of stock.
Wish i hadn't wasted my money to be honest and switched back to the factory nozzle after 3 days of questionable and failed prints.
Now that kinda says it all - going back to a factory nozzle over a pretty darn expensive nozzle replacement.
PLA, PetG, Carbon PetG, woodfill, tpu all had very poor printing results due to the nozzle getting clogged up!
Not blockages just filament getting dragged around by the nozzle and getting all gooped up with filament.
They should change the description from 'Low friction coefficient' to High friction coefficient lol.
I was generous with my stars purely because this may have been my own fault as this seems to be marketed for high temp filaments, that i don't often use and haven't tested it with.
After the farce i had with regular filaments it may never come back out of the junk box tbh!
On another note i may possible have received a faulty, badly machined or incorrectly sized nozzle?
My .4mm cleaning pin jammed so tight in the nozzle i needed to use pliers to remove it!
Very unusual is that this brand does NOT have the size stamped on the nozzle, so in retrospect it is entirely possible that a smaller diameter nozzle found it's way in to a packet marked with .4mm!
Was this rating helpful? (4) (0)